To ensure optimal performance, consistent image quality, and a longer lifespan, follow these placement guidelines:

1. Open, Flat Surface: Place the projector on a stable, open surface. Avoid placing it directly against walls or inside enclosed spaces (such as tight bookshelves or cabinets).

2. 50 cm (20 in.) Clearance: Leave at least  20 inches (50 cm)** of open space around the sides and rear of the projector.

3. Unobstructed Vents: Keep all air intake and exhaust vents completely clear of dust, curtains, or other objects to prevent overheating.

Yes, it includes Autofocus, Auto Keystone Correction, Auto Screen Detection, and Intelligent Obstacle. You can also enable advanced auto settings for autofocus and keystone correction upon startup or after moving the projector.

Yes, the PJ40 Max supports ceiling mounting (ceiling mount sold separately). Simply remove the four corner rubber feet on the bottom of the projector to access the mounting holes, and use the following specifications to find a compatible mount: 

- For screw sizing, the projector features four M4 x 6mm mounting thread holes. 

- For bracket spacing, the distance between the mounting holes is 11.8" diagonal, 8.27" horizontal, and 8.27" vertical.

Yes, you can adjust the image size using the digital zoom function. Adjust the image without moving the projector.
Go to Settings > Image correction > Zoom & Shift. Use the + / - buttons on the remote to zoom the image, which will make the projected image smaller. After you’ve zoomed out, you can press Arrows buttons to move the projection as needed.

Autofocus and Auto Keystone Correction deliver a clear, properly aligned image in seconds. These features are enabled by default, but you can choose to disable them.

Disable Autofocus

Focuses the projector at startup and after the projector is moved. To disable Autofocus, go to Settings > Image correction > Focus, and disable all the functions below:

• Autofocus on Startup
• Autofocus upon Motion

Disable Auto Keystone Correction

Aligns the image at startup, when the projector is moved, and when obstacles are detected. To disable Auto Keystone Correction, go to Settings > Image correction > Auto keystone correction, then disable all the functions below:

• Auto Keystone Correction At Startup
• Auto Keystone Upon Motion

Go to Settings > Display & Sound > Brightness mode to adjust the brightness to your preference.
Choose from three brightness modes: Bright Mode, Standard Mode, and Quiet Mode.